Label-free chemiresistive immunosensors for viruses.

We report development, characterization, and testing of chemiresistive immunosensors based on single polypyrrole (Ppy) nanowire for highly sensitive, specific, label free, and direct detection of viruses. Bacteriophages T7 and MS2 were used as safe models for viruses for demonstration. Ppy nanowires were electrochemically polymerized into alumina template, and single nanowire based devices were assembled on a pair of gold electrodes by ac dielectrophoretic alignment and anchored using maskless electrodeposition. Anti-T7 or anti-MS2 antibodies were immobilized on single Ppy nanowire using EDC-NHS chemistry to fabricate nanobiosensor for the detection of corresponding bacteriophage. The biosensors showed excellent sensitivity with a lower detection limit of 10(-3) plaque forming unit (PFU) in 10 mM phosphate buffer, wide dynamic range and excellent selectivity. The immunosensors were successfully applied for the detection of phages in spiked untreated urban runoff water samples. The results show the potential of these sensors in health care, environmental monitoring, food safety and homeland security for sensitive, specific, rapid, and affordable detection of bioagents/pathogens.

Effect of (L:D) Aspect Ratio on Single Polypyrrole Nanowire FET Device.

Effect of different aspect ratio (length to diameter ratio, L:D) on single polypyrrole (Ppy) nanowire based field effect transistor (FET) sensor for real time pH monitoring was studied. Ppy nanowires with diameters of ~60, ~80 and ~200 nm were synthesized using electrochemical deposition inside anodized aluminium oxide (AAO) template and were assembled using AC dielectrophoretic alignment followed by maskless anchoring on a pair of gold electrodes separated with different gap lengths. Microfabricated gold electrode patterns with gap size between 1 - 4 µm were developed by means of MEMS technique (photolithography). Using field effect transistor geometry with pair of microfabricated gold contact electrodes serving as a source and a drain, and a platinum (Pt) mesh (anchored in a microfluidic channel) was used as a gate electrode. When effect of different aspect ratio of the nanowire were compared, higher sensitivity was recorded for higher aspect ratio. The sensitivity was further improved by modulating the gate potential. These FET sensors based on single polypyrrole nanowire exhibited excellent and tunable sensitivity towards pH variations.

Single conducting polymer nanowire chemiresistive label-free immunosensor for cancer biomarker.

A simple and cost-effective, all-electrochemical method to fabricate and assemble single conducting polymer nanowire based biosensors was developed. Polypyrrole (Ppy) nanowires were synthesized by electrochemical polymerization using an alumina template. The single-nanowire chemoresistive sensor device was assembled using ac dielectrophoretic alignment followed by maskless anchoring on a pair of gold electrodes separated by 3 microm. To establish an efficient covalent surface biofunctionalization route, glutaraldehyde (GA) and N-(3-dimethylaminopropyl)-N'-ethylcarbodiimide hydrochloride (EDC) chemistries were compared. EDC was established to be the most effective chemistry and was used to surface-functionalize a single Ppy nanowire with cancer antigen (CA 125) antibody to fabricate a nanoimmunosensor for CA 125 biomarker detection and quantification. The immunosensor had excellent sensitivity with a lower detection limit of 1 U/mL CA 125 and dynamic range up to 1000 U/mL in 10 mM phosphate buffer. Furthermore, there was no loss of performance upon exposure to CA 125 in spiked human blood plasma. This demonstrates the clinical importance of these sensors for cancer marker detection with cost benefits and great portability for diagnosis of patients at the point of care.